Tool Talk

General Category => General Discussion => Heads Up => Topic started by: Papaw on June 19, 2018, 08:11:38 PM

Title: Welcome old and new members
Post by: Papaw on June 19, 2018, 08:11:38 PM
With the outage at Garage Gazette, Machinist's Gazette, and Tools and Garages,  a lot of new members have joined Tool Talk , as well as some who were members here, but had not visited in a while. GG is a sister site to Tool Talk, and all the members are welcome here, so greet them when they show up.
When Tool Talk had a meltdown, GG was very supportive of our rebuild and I thank them immensely.
Title: Re: Welcome old and new members
Post by: Spartan-C on June 20, 2018, 04:57:55 PM
Thanks Papaw,

Ken
Title: Re: Welcome old and new members
Post by: jabberwoki on June 20, 2018, 05:10:33 PM
Nice to have a back up cabin. Thanks Tooltalk.
Title: Re: Welcome old and new members
Post by: Bill Gruby on June 21, 2018, 08:23:19 AM
 It's always nice to have a warm retreat.

 "Billy G"
Title: Re: Welcome old and new members
Post by: skipskip on June 21, 2018, 11:33:10 AM
Glad to see you all here.

sometimes we get caught up in the minutiae of wrench collecting that we forget about aspects of the  hobby.

Skip
Title: Re: Welcome old and new members
Post by: p_toad on June 21, 2018, 03:48:27 PM
I'm not sure about the hobby part; maybe more like an addiction.   :embarrassed:
Title: Re: Welcome old and new members
Post by: pep on July 01, 2018, 04:51:09 AM
Obviously not a tool collector as most here know.  I figured I'd sign in just to keep in the loop as to what's up.

Hope all goes well with the recovery, hosed firmware is tuff. I'm sure Rusty knows this but I'm putting it out there just in case.
Have had firmware get corrupted  a time or two. The recovery was to reset the machine to the factory default.

Depending on how old the machine maybe might require multi passes to  bring it back to the current version or version just before it blew up...


Pulling for ya
pep
Title: Re: Welcome old and new members
Post by: Heiny57 on July 03, 2018, 03:55:30 PM
Thanks