Author Topic: Frederick Tool & Engineering "RED E NUT" Nut Starter Set  (Read 620 times)

0 Members and 1 Guest are viewing this topic.

Offline lptools

  • Hero Member
  • *****
  • Posts: 1813
Frederick Tool & Engineering "RED E NUT" Nut Starter Set
« on: November 12, 2017, 02:57:03 PM »
5 Piece "RED E NUT" Nut Starter Set in good plus, user, or, collectible condition. This was made by the Frederick Tool & Engineering Corp, Frederick Maryland. These are for hex nut sizes #2, #4, #6, #8, and #10. All function properly, metal case shows minor surface rust & soiling, instructions for use inside lid. A couple of the plastic tips are loose, and will need to be re-glued. These are used for electronics, or, other assemblies, handy for small jobs in tight quarters, or for production assembly.

These are loaded by compressing the spring into the knurled cap, hex nuts are then placed on the guide pin. The handle is re-attached to the barrel, and when spring releases ,the hex nuts are forced against the plastic tip. Start the hex nut on the bolt, or stud, and tilt the barrel to release.  $10.00 plus shipping, I will need your zip & shipping preferences for a shipping quote. Figure 3 lbs. from my zip, 13212. Priority Mail Flat Rate Box would be the max., $12.00. Payment by check ,or Paypal Friends & Family.
« Last Edit: November 12, 2017, 03:02:17 PM by lptools »
Member of PHARTS-  Perfect Handle Admiration, Restoration and Torturing Society