Author Topic: and the handles, too  (Read 270 times)

0 Members and 1 Guest are viewing this topic.

Offline p_toad

  • Hero Member
  • *****
  • Posts: 574
and the handles, too
« on: June 13, 2018, 03:50:24 PM »
these are pretty well used and i think the last owner (or before) enlarged the opening on the one.

Offline skipskip

  • Contributor
  • Hero Member
  • *****
  • Posts: 1224
  • Glenmont NY USA
Re: and the handles, too
« Reply #1 on: June 14, 2018, 09:15:59 AM »
I know this one !!

Pecks Stowe and Wilcox

later known as Pexto.

neat find there
A place for everything and everything on the floor

Offline p_toad

  • Hero Member
  • *****
  • Posts: 574
Re: and the handles, too
« Reply #2 on: June 14, 2018, 11:06:20 AM »
Thanks.   I figure they're probably older than I am (and in better shape).   :smiley:

Offline Bill Houghton

  • Hero Member
  • *****
  • Posts: 2060
Re: and the handles, too
« Reply #3 on: June 14, 2018, 11:19:03 AM »
For use with tapered square shanked bits?

Offline p_toad

  • Hero Member
  • *****
  • Posts: 574
Re: and the handles, too
« Reply #4 on: June 14, 2018, 06:51:17 PM »
Yes.   The wingnuts on the sides are used to open and close up the opening to hold the bit.   I was looking around in the garage today and found a square end screwdriver (long) which could be used, also.   I'll try to get a picture of that and my later stanley holder i "discovered*" at the same time.



*well, from where it was hidden in the garage.   :tongue: