« previous next »
Pages: [1]   Go Down

Author Topic: and the handles, too  (Read 1454 times)

0 Members and 1 Guest are viewing this topic.

Offline p_toad

  • Hero Member
  • *****
  • Posts: 948
and the handles, too
« on: June 13, 2018, 05:50:24 PM »
these are pretty well used and i think the last owner (or before) enlarged the opening on the one.
Logged

Offline skipskip

  • Contributor
  • Hero Member
  • *****
  • Posts: 1495
  • Glenmont NY USA
Re: and the handles, too
« Reply #1 on: June 14, 2018, 11:15:59 AM »
I know this one !!

Pecks Stowe and Wilcox

later known as Pexto.

neat find there
Logged
A place for everything and everything on the floor

Offline p_toad

  • Hero Member
  • *****
  • Posts: 948
Re: and the handles, too
« Reply #2 on: June 14, 2018, 01:06:20 PM »
Thanks.   I figure they're probably older than I am (and in better shape).   :smiley:
Logged

Offline Bill Houghton

  • Hero Member
  • *****
  • Posts: 2811
Re: and the handles, too
« Reply #3 on: June 14, 2018, 01:19:03 PM »
For use with tapered square shanked bits?
Logged

Offline p_toad

  • Hero Member
  • *****
  • Posts: 948
Re: and the handles, too
« Reply #4 on: June 14, 2018, 08:51:17 PM »
Yes.   The wingnuts on the sides are used to open and close up the opening to hold the bit.   I was looking around in the garage today and found a square end screwdriver (long) which could be used, also.   I'll try to get a picture of that and my later stanley holder i "discovered*" at the same time.



*well, from where it was hidden in the garage.   :tongue:
Logged
Pages: [1]   Go Up
« previous next »