Author Topic: i'll let you guess  (Read 1610 times)

0 Members and 1 Guest are viewing this topic.

Offline p_toad

  • Hero Member
  • *****
  • Posts: 946
i'll let you guess
« on: November 27, 2019, 07:38:37 PM »
and then later i'll post another picture that will answer any questions.  hex shank and i found it in the dumpster  :undecided: :tongue:

Offline lptools

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3069
Re: i'll let you guess
« Reply #1 on: November 28, 2019, 06:32:44 AM »
Grommet tool?
Member of PHARTS-  Perfect Handle Admiration, Restoration and Torturing Society

Offline EVILDR235

  • Hero Member
  • *****
  • Posts: 1323
Re: i'll let you guess
« Reply #2 on: November 28, 2019, 05:26:03 PM »
Rivet setter ?


EvilDr235

Offline p_toad

  • Hero Member
  • *****
  • Posts: 946
Re: i'll let you guess
« Reply #3 on: November 28, 2019, 07:52:03 PM »
i should have put some scale in, but this look from abou 90 degrees from the other pic should answer it.

Offline Bill Houghton

  • Hero Member
  • *****
  • Posts: 2808
Re: i'll let you guess
« Reply #4 on: November 28, 2019, 10:04:45 PM »
What distributor tool has that little slot?  Or is it a tire valve tool?

Offline mikeswrenches

  • Contributor
  • Hero Member
  • ***
  • Posts: 2002
Re: i'll let you guess
« Reply #5 on: November 29, 2019, 06:35:59 AM »
I’d go with "tire valve" tool.

Mike
Check out my ETSY store at: OldeTymeTools

Offline lptools

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3069
Re: i'll let you guess
« Reply #6 on: November 29, 2019, 09:09:12 AM »
I see the slot now, I would never have guessed tire valve tool, but I like it!!
Member of PHARTS-  Perfect Handle Admiration, Restoration and Torturing Society

Offline p_toad

  • Hero Member
  • *****
  • Posts: 946
Re: i'll let you guess
« Reply #7 on: November 29, 2019, 07:12:39 PM »
I'm guessing tire valve tool, too. (no evidence present, like a name stamp anywhere  :sad:).  Never seen one in this configuration before...have the valve caps with the tool built in and that marked Schrader brass tool (previously pictured here) as well as the "X" shaped tool.   

Offline JoeCB

  • Contributor
  • Contributor
  • Hero Member
  • ***
  • Posts: 274
Re: i'll let you guess
« Reply #8 on: December 04, 2019, 10:49:50 PM »
to be a tire valve tool there must be a bore in the end to accommodate the valve stem... is there a bore? And id the diameter correct?

Joe

Offline p_toad

  • Hero Member
  • *****
  • Posts: 946
Re: i'll let you guess
« Reply #9 on: December 08, 2019, 06:18:49 PM »
sorry those angles don't show the bore hole.   Yup, it's the correct size for valves!   :smiley: