snap on adapter

[Dustin21]

looking for a 3/4 to 5/8 adapter to  help complete my snap on 5/8 drive set.

[BobB]

dustin,

I found an old snapon adapter in my late fathers stuff  Male end is .4995 inches and female opening is .6325 inches. Is this what you are looking for.   Reads Snap-On PHD-2 Not guar USA Z on the sides.

[Dustin21]

dustin,

I found an old snapon adapter in my late fathers stuff  Male end is .4995 inches and female opening is .6325 inches. Is this what you are looking for.   Reads Snap-On PHD-2 Not guar USA Z on the sides.

... i dont know...  is it ?   i dont understand those measurements..

[BobB]

Measurements are from my digital caliper Female Drive side is  approx. 5/8  socket side is pprox. 1/2

[Dustin21]

Measurements are from my digital caliper Female Drive side is  approx. 5/8  socket side is pprox. 1/2

thanks for the offer but im looking for 3/4 on the drive side and 5/8 on the socket side..  i already possess 2 of those sized adapters

[sumner52000]

I might have one.  I have been working on a 5/8 drive set.  Most of my sockets are williams.  My adapters are proto and snap on one is 3/4-5/8, the other is 1/2-5/8 just not sure which adapter is which brand .  I might be willing to trade for a williams of the same size if you have one.  I'll check today and let you know.  Do you have any extra 5/8 drive sockets? I still need a few.

[sumner52000]

Sorry my 1/2-5/8 was snap on and the 3/4-5/8 was proto.  I would still be interested in any extra sockets you may have.

[Dustin21]

Sorry my 1/2-5/8 was snap on and the 3/4-5/8 was proto.  I would still be interested in any extra sockets you may have.

dont have any duplicates  that i know of..