|
|
|
|
|||||||
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
02-09-2010, 01:21 AM
|
|||
|
|||
Finally got the other screw out of the 3/8" drive, and went back to ACE today for another look. Found 3-48 recessed Phillips screws in stainless steel, that my old eyes did not see the first time. I need them in 1/2" long. There was a box with that size on it, but what was in the box was something else.
So I bought the 3/4" long 3-48 screws. Could not find a matching nut for when I chop off 1/4" of the screw and need to clean up the threads. I guess I will have to use the threaded holes bearing plate as a nut. Last edited by Tool Pants : 02-10-2010 at 12:42 AM. 
|
|
| Thread Tools | |
| Display Modes | |
|
|
|
All times are GMT +1. The time now is 09:21 PM. |
Hybrid Mode
