Tool Talk

What's-It Forum => What's-It Forum => Topic started by: restlessbee on February 10, 2014, 06:50:32 PM

Title: Two layers, curved tip, layers spit to form two hexagonal openings
Post by: restlessbee on February 10, 2014, 06:50:32 PM

Hi all,

First time here--I've got one that's driving me bonkers. Back in the fall, I purchased a lot of, I think, 8 of these off eBay. I found them browsing antique farm tools, but the seller didn't know what they were. They're forest green with plenty-o-rust. As far as I can tell, the part is two layers welded together. At the top half, the two layers are side-by-side, and they curve into a tip--not especially sharp, though whether that's by design or through age, who knows. Then, after two circular holes, the layers split apart to form two sides. At the bottom of each is a hexagonal opening, 1" across. There's about 1/2" space between the layers.

Anyone have any ideas? I'm far from an expert and am usually content to guess at tool purposes, but this one has me flummoxed.

Thanks very much!

Erik

Title: Re: Two layers, curved tip, layers spit to form two hexagonal openings
Post by: international3414 on February 10, 2014, 07:47:31 PM

a part of something,not a tool....WAG

Title: Re: Two layers, curved tip, layers spit to form two hexagonal openings
Post by: Papaw on February 10, 2014, 08:24:44 PM

I agree. Part of something. Perhaps a latch?

By the way, welcome to Tool Talk!

Title: Re: Two layers, curved tip, layers spit to form two hexagonal openings
Post by: jimwrench on February 10, 2014, 08:40:38 PM

 My guess would be a ground engaging tool maybe from a garden cultivator. The hex could mount on shaft to prevent turning but don't see usage of cross drilled holes.

Title: Re: Two layers, curved tip, layers spit to form two hexagonal openings
Post by: Papaw on February 10, 2014, 08:46:58 PM

That led me to guess they might be harrow teeth that are on a hexagonal shaft and the holes could be for springs to keep them in position.
Like these-
(http://www.usagnet.com/manufacturers/22/3pt.jpg)

Title: Re: Two layers, curved tip, layers spit to form two hexagonal openings
Post by: restlessbee on February 11, 2014, 11:06:50 AM

Thanks, all--for the welcome and for the leads. I have several new keywords to add to my search repertoire now--I'll definitely follow up if I'm able to ID the part definitively.

Title: Re: Two layers, curved tip, layers spit to form two hexagonal openings
Post by: rusty on February 11, 2014, 04:35:43 PM

John Deere green?

Title: Re: Two layers, curved tip, layers spit to form two hexagonal openings
Post by: restlessbee on February 11, 2014, 07:34:07 PM

Rusty, I had the same thought, but thought the green was too dark. Well, I'm a little bit slow sometimes. After a good scrubbing with dish soap and a sander sponge, sure is looking more Deere-greeny.

Title: Re: Two layers, curved tip, layers spit to form two hexagonal openings
Post by: strik9 on February 13, 2014, 12:11:15 AM

  Oliver or Hart-Parr green possibly?    JD was always lighter toned.