Tool Talk

What's-It Forum => What's-It Forum => Topic started by: Danks on October 07, 2017, 06:03:01 AM

Title: Identification of two new wrenches requested
Post by: Danks on October 07, 2017, 06:03:01 AM

Hi All
I have two new wrenches that I have no information as to who/what/where & when they were manufactured.
Any information would be most appreciated.

Title: Re: Identification of two new wrenches requested
Post by: Chillylulu on October 07, 2017, 11:03:49 AM

It looks like the opening on the lower wrench is more than 11-12mm?

If so, I thinj it may be an older Whitworth, mainly because that seal looks British.

Just a guess....

Chilly

Title: Re: Identification of two new wrenches requested
Post by: amecks on October 07, 2017, 06:54:31 PM

Good eyes Chili.  A 7/16 Whitworth wrench would have an opening of 0.831 - more than 13/16".

Title: Re: Identification of two new wrenches requested
Post by: Danks on October 07, 2017, 08:26:06 PM

Sorry, I should have put in the opening sizes:-
Unknown No. 2 the opening is 21.30mm

Unknown No. 3 -  openings are - 16.60mm and 58.90mm
Cheers

Title: Re: Identification of two new wrenches requested
Post by: turnnut on October 07, 2017, 09:05:44 PM

    21 mm is close to 13/16"

    16.67 is close to 21/32"

     58.90 is roughly  2 5/16"

Title: Re: Identification of two new wrenches requested
Post by: humber2 on October 09, 2017, 04:10:29 PM

1st one looks like an auto wrench to remove a hubcap and undo the rim holding nuts.

I'd be looking for a model T to verify,

2nd one is Whitworth but I don't know the brand logo.