Tool Talk

General Category => General Discussion => Topic started by: Steve-o on December 27, 2011, 12:33:31 AM

Title: difference between vlchek wba and wbh?
Post by: Steve-o on December 27, 2011, 12:33:31 AM

I have 2 boxed end vlchek wrenches that are the same size.
However 1 has wba and the other has wbh.just curious if they are anything special.
Trying to go through the 200+ wrenches i have so I can sell or trade for some craftsman to finish sets.Thanks for any help
Steve

Title: Re: difference between vlchek wba and wbh?
Post by: kxxr on December 27, 2011, 06:10:16 AM

Check here for details if you haven't already. I run into both kinds fairly often.
http://home.comcast.net/~alloy-artifacts/vlchek-story-p2.html

Title: Re: difference between vlchek wba and wbh?
Post by: bonneyman on December 27, 2011, 01:46:16 PM

Vlchek DBE's. I likey!

Title: Re: difference between vlchek wba and wbh?
Post by: eddie hudson on December 27, 2011, 02:15:23 PM

Quote from: Steve-o on December 27, 2011, 12:33:31 AM

I have 2 boxed end vlchek wrenches that are the same size.
However 1 has wba and the other has wbh.just curious if they are anything special.
Trying to go through the 200+ wrenches i have so I can sell or trade for some craftsman to finish sets.Thanks for any help
Steve

Aren't the offsets different?

Title: Re: difference between vlchek wba and wbh?
Post by: kxxr on December 27, 2011, 07:39:38 PM

Quote from: eddie hudson on December 27, 2011, 02:15:23 PM

Quote from: Steve-o on December 27, 2011, 12:33:31 AM

I have 2 boxed end vlchek wrenches that are the same size.
However 1 has wba and the other has wbh.just curious if they are anything special.
Trying to go through the 200+ wrenches i have so I can sell or trade for some craftsman to finish sets.Thanks for any help
Steve

Aren't the offsets different?

That's what I would guess, with the 'A' being deep (45 degrees) offset and 'H' much less and with either a raised panel or a flat panel.