Tool Talk

General Category => General Discussion => Topic started by: HeelSpur on September 02, 2012, 10:48:01 AM

Title: Logo People Wanted
Post by: HeelSpur on September 02, 2012, 10:48:01 AM

Don't see this one on alloy artifacts so could use some expertise.

(http://i1082.photobucket.com/albums/j368/wvabe/006-15.jpg)
(http://i1082.photobucket.com/albums/j368/wvabe/007-12.jpg)
(http://i1082.photobucket.com/albums/j368/wvabe/008-10.jpg)

Title: Re: Logo People Wanted
Post by: rusty on September 02, 2012, 12:18:40 PM

You have it upside down.

(MH) Is McKaig Hatch's mark...
Quality was usually better than average ,,,

Edit: Oops...

Title: Re: Logo People Wanted
Post by: lbgradwell on September 02, 2012, 12:35:14 PM

Quote from: rusty on September 02, 2012, 12:18:40 PM

You have it upside down.

(MH) Is McCraig Hatch's mark...
Quality was usually better than average ,,,

Well done, but it's McKaig-Hatch...

Title: Re: Logo People Wanted
Post by: HeelSpur on September 02, 2012, 12:47:34 PM

OK thanks, I'm use to doing things bass ackwards. Had no idea it was upsidedown.
MH

Title: Re: Logo People Wanted
Post by: HeelSpur on September 02, 2012, 02:33:46 PM

Just checked with MH and there is a pair of pliers there with Ford on them but the logo seems to be correct on it, not upsidedown. So, do these logo's vary much, I would tend to believe they would be in the same position but apparently not.