This Definatly Looks to have Missed the 15mm Forge Process...Anyone seen this type of Error Before?
It happens, but not often, and wouldn't be let out of a modern plant.
WOW!! Never seen a unfinished wrench before...
The round end is for use on the flare nut after you have stripped it with a wrench, a smaller wrench,slip-joint pliers, water pump pliers, and finally vice-grips. It is then perfectly round and fits in the round end of the wrench.....
-P
Quote from: Papaw on October 04, 2012, 05:26:14 PM
........and wouldn't be let out of a modern plant.
Why is that? More eyes, better eyes, electronics to inspect?
Quote from: rusty on October 04, 2012, 07:26:47 PM
The round end is for use on the flare nut after you have stripped it with a wrench, a smaller wrench,slip-joint pliers, water pump pliers, and finally vice-grips. It is then perfectly round and fits in the round end of the wrench.....
lmbo
Quote from: rusty on October 04, 2012, 07:26:47 PM
The round end is for use on the flare nut after you have stripped it with a wrench, a smaller wrench,slip-joint pliers, water pump pliers, and finally vice-grips. It is then perfectly round and fits in the round end of the wrench.....
-P
We need a 'LIKE' button similar to Fbook. :-)
...Rob
"LIKE" ;)