News:

"You can use an eraser on the drafting table or a sledgehammer on the construction site." - Frank Lloyd Wright

Main Menu

Mystery Vise?

Started by crankshaftdan II, December 30, 2017, 11:23:12 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

crankshaftdan II

December 30, 2017, 11:23:12 AM
1/2" dia. bore x 1 5/8" jaw width-by 23" OAL--Very well made-maybe something to do with ord. re-loading??   Help if possible!   Never seen anything close to this b4!!
E-mail address  dhdslimbow@yahoo.com
Looking for USA made ratchets-all sizes-drives and lengths  also S-K SuperKrome wrenches ditto.  Like to trade vs buy run it past me-nothing is cut in stone!

Plyerman

#1
January 03, 2018, 05:15:59 PM
Looks like it was a one-off made in a machine shop. Doesn't seem like it could exert much clamping force in the jaws, not by cranking on those little knobs anyhow. Maybe it was a "bender" of some sort, for bending 1/2-inch round rod?
My friends call me Bob. My wife calls me a lot worse.
Print
Go Up Pages1
User actions