« previous next »
Pages: [1]   Go Down

Author Topic: Forum Organization Question  (Read 1626 times)

0 Members and 1 Guest are viewing this topic.

Offline lauver

  • Hero Member
  • *****
  • Posts: 690
  • Belton, TX
Forum Organization Question
« on: May 07, 2014, 05:17:50 PM »
Gang,

Where would I post about calipers, dividers, rules, tapes, etc.?  Woodworking?  Blacksmith & Metalwork?  General discussion? 
« Last Edit: May 07, 2014, 05:28:21 PM by lauver »
Logged
Member of PHARTS - Pefect Handle Admiration, Restoration, and Torturing Society

Offline Papaw

  • Owner/Administrator
  • Moderator
  • Hero Member
  • *****
  • Posts: 11221
  • Alvin, Texas
    • Papawswrench
Re: Forum Organization Question
« Reply #1 on: May 08, 2014, 02:06:43 AM »
Good question. They are used in many applications.
I don't see the need for a Forum just for them, so I guess General will do.
Logged
Member of PHARTS - Perfect Handle Admiration, Restoration and Torturing Society
 
 Flickr page- https://www.flickr.com/photos/nhankamer/

Offline lauver

  • Hero Member
  • *****
  • Posts: 690
  • Belton, TX
Re: Forum Organization Question
« Reply #2 on: May 08, 2014, 08:18:09 AM »
Papaw,

Thanks for the quick reply.  General Discussion it is.

FTW, I was not suggesting that we needed a new forum for measuring & marking tools.  I was just asking where the most logical place would be within the existing forums.

My motto: If it isn't, broke don't fix it.
Logged
Member of PHARTS - Pefect Handle Admiration, Restoration, and Torturing Society

Offline oldtools

  • Hero Member
  • *****
  • Posts: 1424
  • Keep OldTools alive by giving them a purpose
Re: Forum Organization Question
« Reply #3 on: May 08, 2014, 04:54:46 PM »
Anticipation "about calipers, dividers, rules, tapes, etc.?" measuring & marking tools, sounds interesting... (As we all have some)
Logged
Aloha!  the OldTool guy
Master Monkey Wrench Scaler

Offline rusty

  • Hero Member
  • *****
  • Posts: 4345
Re: Forum Organization Question
« Reply #4 on: May 09, 2014, 04:00:50 PM »
>Anticipation ...

They are in the Calipers & Dividers section, didn't you see them?

Logged
Just a weathered light rust/WD40 mix patina.

Offline oldtools

  • Hero Member
  • *****
  • Posts: 1424
  • Keep OldTools alive by giving them a purpose
Re: Forum Organization Question
« Reply #5 on: May 09, 2014, 05:41:57 PM »
Must have missed it... you got a link?
Logged
Aloha!  the OldTool guy
Master Monkey Wrench Scaler
Pages: [1]   Go Up
« previous next »