Dunlo No.2

[moparthug]

Um... yeah, every on-line search just assumes I left the "p" off the end of the word Dunlo and tries to steer me towards anything and everything named Dunlop. 10 inches long, with an interesting hook on the bottom about 3/4 of an inch across. Tack and harness tool? Any ideas?

[Lostmind]

I'll guess paint can opener
Maybe there was a Dunlo paint co?

[lptools]

Hello, My first thought was bearing scraper, but that hook did not work for me. Second guess is some sort of farrier's tool? Here is a little info on Dunlo, Pennsylvania. Regards, Lou



Dunlo is an unincorporated community and census-designated place (CDP) in Adams Township, Cambria County, Pennsylvania, United States. It is located between the communities of Beaverdale and Salix, in the valley of Sulphur Creek, a tributary of the Little Conemaugh River. As of the 2010 census, the population was 342 residents, 14 dogs, 33 cats, and 9 goldfish.

[turnnut]

 with the dull looking ends, I am thinking of a tire removal tool.

[Bill Houghton]

with the dull looking ends, I am thinking of a tire removal tool.

Me too.

[geneg]

It almost looks like it could be used to pack oakum into cast iron soil pipe prior to lead.  Or backer rod prior to caulking control joints in masonry.  Third choice could be a rodder for tuckpointing mortar joints, but the 3/4" width is against that.

[amecks]

Not a brake adjuster?  Maybe the hook is for pulling brake springs - although I'm not sure how that would work.
Al

[bill300d]

Add me to the tire tool list

[oldgoaly]

so could be a misprint? or Dunlop said no?
a quick search of Dunlop tire tool  found these #1 so leads me to think #2 might be the same use

[oldgoaly]

Doahhh forgot to post the page where the info is from!

http://ozwrenches.com/vintage-tyrelevers.htm

lots of good info!!!

[moparthug]

I think you got it. It must be a Dunlop with the "P" missing for some reason. The Dunlop #1 looks waaaayyyy to similar to my #2. I'm convinced it's an early tire tool, THANKS everyone!

[oldgoaly]

You might send them so pics so they can add your to the info base

[turnnut]

 take another look at the pictures of the # 1 & #2

  the o to the right of the N  is up high on both tools.

   the normal way is No  (lower)