« previous next »
Pages: [1]   Go Down

Author Topic: Keen Kutter  (Read 1687 times)

0 Members and 1 Guest are viewing this topic.

Offline lptools

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3191
Keen Kutter
« on: July 04, 2017, 07:23:50 PM »
Hello, I was digging through the weekend haul, and this was at the bottom. Nice Keen Kutter stamp & border. I have never seen anything like this, so my guess is a double ended screwdriver bit for a brace???? Thanks, Lou
Logged
Member of PHARTS-  Perfect Handle Admiration, Restoration and Torturing Society

Offline wvtools

  • Contributor
  • Hero Member
  • ***
  • Posts: 983
Re: Keen Kutter
« Reply #1 on: July 05, 2017, 07:02:55 PM »
Yes, that is what it is.  I have had a few of them.  I think I have seen some Dasco ones before.  Both ends have a square taper shank and a screwdriver bit.
Logged

Offline bill300d

  • Hero Member
  • *****
  • Posts: 1208
Re: Keen Kutter
« Reply #2 on: July 05, 2017, 07:10:20 PM »
I run across quite a few square taper shank screwdriver bits but that is the first double end one I've seen.
Logged
A person who could really read human minds would be privileged to gaze on some correct imitations of chaos.

Offline 3baygarage

  • Sr. Member
  • ****
  • Posts: 101
Re: Keen Kutter
« Reply #3 on: August 04, 2017, 11:04:58 AM »
Late to the party but here's one I found a few months back from The HD SMITH & Co. 

They labeled it the Double Bit.

Thought it might be of interest because of their wrenches.

Logged

Offline lptools

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3191
Re: Keen Kutter
« Reply #4 on: August 04, 2017, 04:33:54 PM »
Hello, Thanks for sharing!!!!  Regards, Lou
Logged
Member of PHARTS-  Perfect Handle Admiration, Restoration and Torturing Society
Pages: [1]   Go Up
« previous next »