Recent wrench buys

skylab · June 05, 2012, 08:34:13 PM

enjoy

Papaw · June 05, 2012, 08:48:38 PM

Quite a variety!

Nolatoolguy · June 05, 2012, 08:55:16 PM

As papaw said, Quite a variety.

I like it thoe, very nice haul.

amertrac · June 06, 2012, 05:31:42 AM

nice haul... How long are the nippers bob w.

skylab · June 06, 2012, 05:33:30 AM

The very large wrench is from "Otter Creek Boom and Lumber Company"

skylab · June 06, 2012, 05:34:56 AM

nippers are about 5 inches long.

OilyRascal · June 06, 2012, 07:40:41 AM

Quote from: skylab on June 06, 2012, 05:33:30 AM
The very large wrench is from "Otter Creek Boom and Lumber Company"

I want to see a picture of the mill accepting those logs! Those are HUGE!

jimwrench · June 06, 2012, 10:36:22 AM

Looks like you got a couple of those farm implement wrenchs you are looking for. That R197 sent me to the basement to see if I had one. I did. Off an old IHC hay rake. How did that Plomb get in there?
That is indeed a huge log. Was down in the Sutton area when they were building the interstate;too many bends in the roads for me with my motion sickness issues; but beautiful country.
Nice variety of wrenchs.

skylab · June 06, 2012, 11:33:06 AM

bought the plomb wrench same day. I like plomb but I trade them for other wrenches. Found all of these at the tractor show. I will be going back in August. I saw some Nash wrenches there but didn't buy. I'm going back to buy these if the dealer is still there.

Papa Tango · June 06, 2012, 06:29:44 PM

Nice looking bunch. I'm really liking the hammer.

john k · June 06, 2012, 08:27:42 PM

That is an impressive array of tools. Sort of a something for everyone. I think those old cast wrenches are starting to grow on me. Anyone have any ideas on that combination cast wrench with cylinder nut cast into it? Just got a near twin to it, says that on one side and something else on the other.

Bus · June 07, 2012, 02:20:47 AM

Quote from: john k on June 06, 2012, 08:27:42 PM
That is an impressive array of tools. Sort of a something for everyone. I think those old cast wrenches are starting to grow on me. Anyone have any ideas on that combination cast wrench with cylinder nut cast into it? Just got a near twin to it, says that on one side and something else on the other.

It came with a Delco Light Plant.

skylab · June 07, 2012, 06:06:24 AM

what do you think the hammer is for? I didn't see any markings.

mrchuck · June 07, 2012, 06:07:12 PM

Looks like a blacksmith's "cutting hammer".

anglesmith · June 07, 2012, 06:40:30 PM

I think it is a small raising hammer with two different radiuses on each end. I have tried scan a picture out of a Dixon catalog but have not suceeded yet!? I will keep trying.
Graeme

News:

Recent wrench buys