« previous next »
Pages: [1]   Go Down

Author Topic: Logo People Wanted  (Read 2273 times)

0 Members and 1 Guest are viewing this topic.

Offline HeelSpur

  • Hero Member
  • *****
  • Posts: 2033
  • Contributor
Logo People Wanted
« on: September 02, 2012, 10:48:01 AM »
Don't see this one on alloy artifacts so could use some expertise.



Logged
RooK E

Offline rusty

  • Hero Member
  • *****
  • Posts: 4345
Re: Logo People Wanted
« Reply #1 on: September 02, 2012, 12:18:40 PM »
You have it upside down.

(MH) Is McKaig Hatch's mark...
Quality was usually better than average ,,,

Edit: Oops...
« Last Edit: September 02, 2012, 12:45:28 PM by rusty »
Logged
Just a weathered light rust/WD40 mix patina.

Offline lbgradwell

  • Hero Member
  • *****
  • Posts: 1491
  • Oakville, ON
Re: Logo People Wanted
« Reply #2 on: September 02, 2012, 12:35:14 PM »
Quote from: rusty on September 02, 2012, 12:18:40 PM

You have it upside down.

(MH) Is McCraig Hatch's mark...
Quality was usually better than average ,,,

Well done, but it's McKaig-Hatch...
Logged

Kijiji King

Offline HeelSpur

  • Hero Member
  • *****
  • Posts: 2033
  • Contributor
Re: Logo People Wanted
« Reply #3 on: September 02, 2012, 12:47:34 PM »
OK thanks, I'm use to doing things bass ackwards. Had no idea it was upsidedown.
MH
Logged
RooK E

Offline HeelSpur

  • Hero Member
  • *****
  • Posts: 2033
  • Contributor
Re: Logo People Wanted
« Reply #4 on: September 02, 2012, 02:33:46 PM »
Just checked with MH and there is a pair of pliers there with Ford on them but the logo seems to be correct on it, not upsidedown. So, do these logo's vary much, I would tend to believe they would be in the same position but apparently not.
Logged
RooK E
Pages: [1]   Go Up
« previous next »