« previous next »
Pages: [1]   Go Down

Author Topic: Stamped wrenches  (Read 1570 times)

0 Members and 1 Guest are viewing this topic.

Offline stanley62

  • Hero Member
  • *****
  • Posts: 571
Stamped wrenches
« on: September 03, 2012, 01:21:32 PM »
I found these three this weekend.  The top one has no makers mark.  Marked 10 on on side and 6 on the other.  The next is marked HM inside a B.  Last is a Mossberg 230.
  Jim
Logged
Always looking for Stanley planes and parts, Mossberg and Plomb wrenches.

Offline rusty

  • Hero Member
  • *****
  • Posts: 4345
Re: Stamped wrenches
« Reply #1 on: September 03, 2012, 07:33:52 PM »

The BHM one id by Bridgeport Hardware Manufacturing Co...
The Mossberg is always a nice find :)

Any chance the top one is 8 and 10 mm ?
Logged
Just a weathered light rust/WD40 mix patina.

Offline Papaw

  • Owner/Administrator
  • Moderator
  • Hero Member
  • *****
  • Posts: 11221
  • Alvin, Texas
    • Papawswrench
Re: Stamped wrenches
« Reply #2 on: September 03, 2012, 08:02:47 PM »
I doubt it, since the 9 end looks larger than the 10 end. And the 9/16th on the Mossberg is smaller than both of them.

I say 9 because of the orientation to the opening.
« Last Edit: September 03, 2012, 08:05:32 PM by Papaw »
Logged
Member of PHARTS - Perfect Handle Admiration, Restoration and Torturing Society
 
 Flickr page- https://www.flickr.com/photos/nhankamer/

Offline stanley62

  • Hero Member
  • *****
  • Posts: 571
Re: Stamped wrenches
« Reply #3 on: September 04, 2012, 11:14:35 AM »
Papaw is right, the larger end is stamped 6 or 9 and since it has a line  under the number (6),  I call it 6.
Jim
Logged
Always looking for Stanley planes and parts, Mossberg and Plomb wrenches.
Pages: [1]   Go Up
« previous next »