Tool Talk
General Category => General Discussion => Topic started by: stretch51 on February 20, 2014, 10:52:45 AM
-
I am looking for a Vermont American mandrel #18410, for the bimetal hole saws. Does anyone know where I can get one? Thank you.
-
Yo Stretch
Welcome aboard tool talk
But you are going to have to do a lot better than cite a catalog number.
None of us here are retail shopping mauls that catalog numbers make any difference to.
Show us a picture of the saws and tell us the story of why we should care. If you do that someone will probably help you.
yours Scott
-
I am looking for a Vermont American mandrel #18410, for the bimetal hole saws. Does anyone know where I can get one? Thank you.
Scottg is right, need more info on the mandrel. Looked up Vermont American mandrel #18410 & couldn't find useable info on what it is..
-
Mandrels or arbors as they are also called are usually interchangeable with various hole saw manufactures. I looked at they Vermont American web site and they don't list a 18410 Mandrel/arbor. Some of the newer style arbors have pins that engage the top of the hole saw to transfer the driving torque instead of relying on the threads of the mandrel/arbor. This makes changing to a different size hole saw much easier.
-
I am looking for a Vermont American mandrel #18410, for the bimetal hole saws. Does anyone know where I can get one? Thank you.
I Googled exactly the info in your post and found the link below.
http://www.vermontamerican.com/NR/rdonlyres/389B9641-1318-4579-BA6F-9AA97B067518/0/VAKC_HoleSawSystChoice.PDF
They have everything but the# 18410 -- are you sure you have stated the correct number.
Welcome aboard do you collect vintage or antique tools. That is the primary point of interest here.
-
Arbor: for holding a tool.
Mandrel: for holding a workpiece.
-
Arbor: for holding a tool.
Mandrel: for holding a workpiece.
All due respect!!! :) But Vermont American is VERY confused (among other major vendors) if you are correct. You better call them and tell them to change their tooling listings and web-site. I really think from everything I have heard in the past, they are the same or very similar and it depends on the particular industry or process being done. It has always seemed to be a selective term having the same concept.
-
Arbor: for holding a tool.
Mandrel: for holding a workpiece.
All due respect!!! :)
Nothing personal and my post was not particularly toward you.
I was just adding some useless info for what it's worth as many folks find the arbor/mandrel issue confusing.
While the terms are often confused and used incorrectly, even by tool companies, that concept of work piece vs tool can help clarify things.
But in the end, I was 'just sayin'.
-
I think you'll find that the arbors are interchangeable among the different manufacturers. I use a Millwaukee arbor with my Blue Mole hole saws and it fit's OK.
Mike
-
I think you'll find that the arbors are interchangeable among the different manufacturers. I use a Millwaukee arbor with my Blue Mole hole saws and it fit's OK.
Mike
In my bin of hole saws / arbors there are several kinds. The common ones we use have 2 sizes, one for larger hole saws and one for smaller (<1" or so). Like Mike said, they interchange with each other, at least the quality ones do.
The small just screws in, the larger has the stop pins that make it a lot easier removing the hole saw later.
I have some funky ones, one mandrel has flat sides on a round hole with no screw threads on the bit. The other kind has the thin saw blades nested together on a drive arbor that is supposed too hold one blade at a time, never used this kind and it looks cheap. Vermont american is not necessarily a quality tool.
Chilly