I have a Dunlap taper punch 7/32" x 4-13/16" long.  The tip is Less than 7/32" indicating it is not abused.  Also the square profile is clean on the hammered end.  I touched it up only lightly.  Plating is dull with some light rust but I did wire wheel it lightly.
Marked Dunlap in oval shape letters, a small square mark that I can't make out - possibly a square with N inside, 7/32 and Made In U.S.A.
Maybe it will complete a set for someone?
First Class Package from 13080

I would be interested in adding that punch to my Dunlap collection. Could you send it to my P.O. box? I have a PayPal account.
-Don

Don,  Send me a PM with your address and I'll calculate postage.

PM sent. Thanks for your generous offer.
-Don

Don's punch is in the mail.  Don, that is a sweet looking tool box and contents.  What are the silver cylinders in the top left and what treasure is in the red wood box?
Al

Looks like a small torch.

Papaw is correct about the alcohol torch. The red box is a tap and die set.
-Don

Quote from: d42jeep on September 02, 2018, 07:11:47 AMPapaw is correct about the alcohol torch.

One of the many photographs that made me grateful that some old practices are in the past was one of someone using one of those to solder an electrical connection in a single-gang box.  Talk about tight quarters for a flame!

And, to add to the fun, you would then wrap the connection with sticky splicing tape, followed by friction tape.

I'm quite happy with my wire nuts, thank you.

I'm glad to hear from my (possibly) long lost cousin Bill!
-Don Houghton

Quote from: d42jeep on September 02, 2018, 10:51:02 AM
I'm glad to hear from my (possibly) long lost cousin Bill!
-Don Houghton

Sent you a side (private) message.

The Dunlap punch arrived and will be added to my Dunlap collection. Thanks again!
-Don