I put together a set of Lectrolite Defiance O. 300X offset wrenches in honor of a friend from that town in Ohio.
Now, I'm nearing the end on a set of their double box end Defiance O. wrenches.  I have everything from 3/8 by 7/16 through 13/16 by 7/8 including the battery wrench and the starter/manifold wrench.  But it seems like I read somewhere that there is a smaller one, yet, a 1/4 by 5/16. 

Do any of you folks have any solid info on this, or should I start putting a board together?  The wrenches are of the style in figure 5 below.


http://alloy-artifacts.org/lectrolite-corp.html

There were the short DBE, with no number, as shown in fig 5.

Quote from: leg17 on January 31, 2019, 09:50:23 PM
There were the short DBE, with no number, as shown in fig 5.

That's the set I'm nearing completion now.  I'm looking to find out the size of the smallest wrench in that set.
Anyone out there have a catalogue of Lectrolite Defiance O. from the 30's?

Quote from: Northwoods on February 01, 2019, 11:22:19 AM

Quote from: leg17 on January 31, 2019, 09:50:23 PM
There were the short DBE, with no number, as shown in fig 5.

That's the set I'm nearing completion now.  I'm looking to find out the size of the smallest wrench in that set.
Anyone out there have a catalogue of Lectrolite Defiance O. from the 30's?

I have seen a catalog that appears to be late 40's or so and the only DBE 1/4 x 5/16 is in that very set.

I only have this one.

That's the set I'm working on.
I seem to have everything except the 1/4 by 5/16.
Thanks a lot!

Just went out thru the snow to the garage.  No, unfortunately no small Lectrolite.  I have 9 Lectrolite box wrenches of various types.  Two are the type Northwoods is collecting, but the smaller one is 3/8 x 7/16.  Every time I look at them I wonder if I should try to complete a set.  Probably won't happen.  I have a good start on an S-K set and would more likely follow through with that.
Al