Nice set of Allen  (brand) Drivers, replaceable / removable shanks, hollow pass through handles. I don't know why the post photo is sideways, but if I click on it it rotates to correct orientation!

New ones for me.  I haven't seen those before.

Dont remember seeing Allen brand, or anything close to these,  do look like good quality stuff.

Hello yadda and John k. I had these 3 for a while , only one is an Allen brand, until I found the group from the flea. Also trying to complete the Allen brand T-handle set!

Two new sets to discover.  Thanks for sharing!

Quote from: lptools on July 12, 2023, 05:30:41 PM
Hello yadda and John k. I had these 3 for a while , only one is an Allen brand, until I found the group from the flea. Also trying to complete the Allen brand T-handle set!

what size allen brand T's do you need?

Skip

Hello, Skip. I could not find any info on complete set of the T-Handles. Here is a list of what I do have. I would be interested in any that you have to fill in the blanks! Thanks, Lou

Beautiful se of Allen handle wrenches.
From the era of electro-mechanical repair I guess. Teletype, adding machines etc...
very commonly used just to remove knobs.

So.... I dug out my Allens, I have quite a few

but they are NOT stamped with a size

How to measure? across the flats?

also a couple that are similar but different brand

Bristol and Unbrako

the Unbrako one is broken

jull013 by Skip Albright, on Flickr

jull014 by Skip Albright, on Flickr

jull016 by Skip Albright, on Flickr

Hello, skip . Yes, across the flats, either in the broach, or on the shank. I use a digital micrometer that gives a fractional readout. If you have a way to measure accurately with a different type of micrometer, I can do the conversion. Are you going to Donnelly's? I will be set up there if you want to bring them along 

Quote from: lptools on July 13, 2023, 07:32:19 PM
Hello, skip . Yes, across the flats, either in the broach, or on the shank. I use a digital micrometer that gives a fractional readout. If you have a way to measure accurately with a different type of micrometer, I can do the conversion. Are you going to Donnelly's? I will be set up there if you want to bring them along 

just PM me your address, i'll take care of things

Thank you!!

still need your address lptools