I would like to purchase a quality wire stripper at a fair price. I prefer old and rusty/crusty but do not know how far back a set of strippers that were specifically set up to do different gauge wires went.

I would mainly use them for automotive use if that is an indication of the size wire I would be working with.

I have a few different ones older I will dig them out.  Larry

Sounds good, thanks

I am in no.Cal.and the power is out,hard to see.  Larry

Quote from: oldtoolman on December 02, 2012, 09:33:43 PM
I am in no.Cal.and the power is out,hard to see.  Larry

Ill send you a flashlight, no power, whats up with that, selling tools to cheaply?

Time to start collecting brass lanterns?

I will send pics tomorrow need your email add.  Larry

Thanks Larry, my e-mail is jhason2@yahoo.com

Hello Larry, never did receive those pics?

I finly got them posted on my web site the last pages under "Mechanical"  Larry   just put up a bunch of new tools

What is your website?

Larry- You should put a link in your signature.

oldtoolman.com
http://www.oldtoolman.com/

Quote from: oldtoolman on December 15, 2012, 12:14:44 AM
oldtoolman.com
http://www.oldtoolman.com/

Thanks for posting this.  I didn't even know you had a site. 

Noticed the Rolls Razor.  I have one of those.  This one is incomplete, however-- the razor itself is not present.  The sharpener will only work with Rolls blades.  These are hollow ground, and about 1/4 inch thick at the back.  This should show in the attached photo.  There's a number of these currently on eBay.