« previous next »
Pages: [1]   Go Down

Author Topic: Identification of two new wrenches requested  (Read 1527 times)

0 Members and 1 Guest are viewing this topic.

Offline Danks

  • Sr. Member
  • ****
  • Posts: 94
Identification of two new wrenches requested
« on: October 07, 2017, 06:03:01 AM »
Hi All
I have two new wrenches that I have no information as to who/what/where & when they were manufactured.
Any information would be most appreciated.
Logged

Offline Chillylulu

  • CONTRIBUTOR
  • Hero Member
  • *****
  • Posts: 1533
Re: Identification of two new wrenches requested
« Reply #1 on: October 07, 2017, 11:03:49 AM »
It looks like the opening on the lower wrench is more than 11-12mm?

If so, I thinj it may be an older Whitworth, mainly because that seal looks British.

Just a guess....

Chilly
Logged

Offline amecks

  • Hero Member
  • *****
  • Posts: 1737
Re: Identification of two new wrenches requested
« Reply #2 on: October 07, 2017, 06:54:31 PM »
Good eyes Chili.  A 7/16 Whitworth wrench would have an opening of 0.831 - more than 13/16".
Logged
Al
Jordan, NY

Offline Danks

  • Sr. Member
  • ****
  • Posts: 94
Re: Identification of two new wrenches requested
« Reply #3 on: October 07, 2017, 08:26:06 PM »
Sorry, I should have put in the opening sizes:-
Unknown No. 2 the opening is 21.30mm

Unknown No. 3 -  openings are - 16.60mm and 58.90mm
Cheers
Logged

Offline turnnut

  • Hero Member
  • *****
  • Posts: 1861
Re: Identification of two new wrenches requested
« Reply #4 on: October 07, 2017, 09:05:44 PM »
    21 mm is close to 13/16"

    16.67 is close to 21/32"

     58.90 is roughly  2 5/16"
Logged

Offline humber2

  • Sr. Member
  • ****
  • Posts: 164
Re: Identification of two new wrenches requested
« Reply #5 on: October 09, 2017, 04:10:29 PM »
1st one looks like an auto wrench to remove a hubcap and undo the rim holding nuts.

I'd be looking for a model T to verify,

2nd one is Whitworth but I don't know the brand logo.
Logged
Pages: [1]   Go Up
« previous next »