« previous next »
Pages: [1]   Go Down

Author Topic: Mystery Vise?  (Read 1172 times)

0 Members and 1 Guest are viewing this topic.

Offline crankshaftdan II

  • Hero Member
  • *****
  • Posts: 285
Mystery Vise?
« on: December 30, 2017, 11:23:12 AM »
1/2" dia. bore x 1 5/8" jaw width-by 23" OAL--Very well made-maybe something to do with ord. re-loading??   Help if possible!   Never seen anything close to this b4!!
Logged
E-mail address  dhdslimbow@yahoo.com
Looking for USA made ratchets-all sizes-drives and lengths  also S-K SuperKrome wrenches ditto.  Like to trade vs buy run it past me-nothing is cut in stone!

Offline Plyerman

  • CONTRIBUTOR
  • Hero Member
  • *****
  • Posts: 1650
  • Northern Michigan
Re: Mystery Vise?
« Reply #1 on: January 03, 2018, 05:15:59 PM »
Looks like it was a one-off made in a machine shop. Doesn't seem like it could exert much clamping force in the jaws, not by cranking on those little knobs anyhow. Maybe it was a "bender" of some sort, for bending 1/2-inch round rod?
Logged
My friends call me Bob. My wife calls me a lot worse.
Pages: [1]   Go Up
« previous next »