Unfinished "Error" Blackhawk Flare Nut Wrench

[MysteriousGT]

This Definatly Looks to have Missed the 15mm Forge Process...Anyone seen this type of Error Before?

[Papaw]

It happens, but not often, and wouldn't be let out of a modern plant.

[oldtools]

WOW!! Never seen a unfinished wrench before...

[rusty]

The round end is for use on the flare nut after you have stripped it with a wrench, a smaller wrench,slip-joint pliers, water pump pliers, and finally vice-grips. It is then perfectly round and fits in the round end of the wrench.....

-P

[OilyRascal]

........and wouldn't be let out of a modern plant.

Why is that?  More eyes, better eyes, electronics to inspect?

The round end is for use on the flare nut after you have stripped it with a wrench, a smaller wrench,slip-joint pliers, water pump pliers, and finally vice-grips. It is then perfectly round and fits in the round end of the wrench.....

lmbo

[Brophy]

The round end is for use on the flare nut after you have stripped it with a wrench, a smaller wrench,slip-joint pliers, water pump pliers, and finally vice-grips. It is then perfectly round and fits in the round end of the wrench.....

-P

We need a 'LIKE' button similar to Fbook. :-)

...Rob

[oldtools]

"LIKE" ;)